--- title: Setting up IPv6 template: docs taxonomy: category: docs --- IPv6 may work out of the box in many cases. But in some cases or some specific provider, you may need to tweak things manually to enable IPv6. ## With a VPS from OVH OVH give one IPv4 address and one IPv6 address for VPS but by default, only IPv4 is OK. The OVH's documentation is here : https://docs.ovh.com/gb/en/vps/configuring-ipv6/ ### Configure the DNS server Here : https://yunohost.org/#/dns_subdomains ### Configure the server On the OVH panel, you will copy 3 element : - the IPv6 address - the IPv6 gateway address - the IPv6 prefix. On OVH's VPS SSD, prefixes are `/128` because you have only *one* IPv6 address. On your VPS, create a backup of the network configuration with : `cp /etc/network/interfaces ~/interfaces` in home directory. Then, you can edit the configuration file (`/etc/network/interfaces`) with the following. It is assumed that :
In this example, it is assumed that your network interface is `eth0`. If it's different (check with `ip a`) you need to adapt the example below.
```plaintext iface eth0 inet6 static address netmask post-up /sbin/ip -6 route add dev eth0 post-up /sbin/ip -6 route add default via dev eth0 pre-down /sbin/ip -6 route del default via dev eth0 pre-down /sbin/ip -6 route del dev eth0 ``` Now, save the file and restart the network service with : `service networking restart`. (TODO : ideally we should find a way to validate the content of the configuration, otherwise it could fuck up the network stack and get disconnected from the VPS ?) Check your configuration with these commands : - `ip a` to display network interfaces and addresses - `hostname -I` to display the system IP addresses - try to ping an IPv6 server (for example you can use `ping6 ip6.yunohost.org`) - try to ping your server from your PC (assuming your PC has IPv6 enabled) If it's ok, it's ok !