# Install YunoHost on ARM board *Find other ways to install YunoHost **[here](/install)**.* <center> <img src="/images/olinuxino.jpg" width=250 style="padding-bottom:20px"> <img src="/images/micro-sd-card.jpg"> </center> <div class="alert alert-info" markdown="1"> Before setting up a server at home, it is recommended that you know the [possible limitations imposed by your ISP](/isp). If they are too restrictive, you might consider using a VPN to bypass them. </div> <div class="alert alert-warning" markdown="1"> YunoHost doesn't yet support ARM64 boards. For more information, see [this issue](https://github.com/YunoHost/issues/issues/438). </div> ## Pre-requisites - An ARM board with 500MHz CPU and 512MB RAM ; - A power supply for your board ; - A microSD card: **8GB** capacity (at least) and **Class 10** speed rate are highly recommended (like the [Transcend 300x](http://www.amazon.fr/Transcend-microSDHC-adaptateur-TS32GUSDU1E-Emballage/dp/B00CES44EO)) ; - An ethernet cable (RJ-45) to connect your board to your router ; - A [reasonable ISP](/isp), preferably with a good and unlimited upload bandwidth. --- ## Install with the pre-installed image (recommended) <a class="btn btn-lg btn-default" href="/images">0. Download the pre-installed image for your board</a><br><small>If no pre-installed image exists for your board, you can follow the instructions to "Install on top of ARMbian"</small> <a class="btn btn-lg btn-default" href="/copy_image">1. Flash the SD card with the image</a> <a class="btn btn-lg btn-default" href="/plug_and_boot">2. Power up the board and let it boot</a> <a class="btn btn-lg btn-default" href="/ssh">3. Connect to your server with SSH</a> <a class="btn btn-lg btn-default" href="/postinstall">4. Proceed with the initial configuration (post-installation)</a> --- ## Install on top or ARMbian <a class="btn btn-lg btn-default" href="https://www.armbian.com/download/">0. Download the ARMbian image for your board</a> <a class="btn btn-lg btn-default" href="/copy_image_fr">1. Flash the SD card with the image</a> <a class="btn btn-lg btn-default" href="/plug_and_boot_fr">2. Plug & boot</a> <a class="btn btn-lg btn-default" href="/ssh_fr">3. Connect to your server with SSH</a> <a class="btn btn-lg btn-default" href="/install_manually_fr">4. Follow the generic install procedure</a>