2.1 KiB
| title | template | taxonomy | routes | ||||
|---|---|---|---|---|---|---|---|
| Install YunoHost on ARM board | docs |
|
|
Find other ways to install YunoHost here.
!!! Before setting up a server at home, it is recommended that you know the possible limitations imposed by your ISP. If they are too restrictive, you might consider using a VPN to bypass them.
Pre-requisites
- An ARM board with 500MHz CPU and 512 MB of RAM;
- A power supply for your board;
- A microSD card: 8GB capacity (at least) and Class 10 speed rate are highly recommended (like the Transcend 300x);
- An ethernet cable (RJ-45) to connect your board to your router;
- A reasonable ISP, preferably with a good and unlimited upload bandwidth.
Install with the pre-installed image (recommended)
[div class="btn btn-lg btn-default"] 0. Download the pre-installed image for your board [/div]
If no pre-installed image exists for your board, you can follow the instructions to "Install on top of ARMbian"
[div class="btn btn-lg btn-default"] 1. Flash the SD card with the image [/div]
[div class="btn btn-lg btn-default"] 2. Boot the board and connect to the web interface at yunohost.local [/div]
[div class="btn btn-lg btn-default"] 3. Proceed with the initial configuration (post-installation) [/div]
Install on top of ARMbian
[div class="btn btn-lg btn-default"] 0. Download the ARMbian image for your board [/div]
[div class="btn btn-lg btn-default"] 1. Flash the SD card with the image [/div]
[div class="btn btn-lg btn-default"] 2. Plug & boot [/div]
[div class="btn btn-lg btn-default"] 3. Connect to your server with SSH [/div]
[div class="btn btn-lg btn-default"] 4. Follow the generic install procedure [/div]