mirror of
https://github.com/YunoHost/doc.git
synced 2024-09-03 20:06:26 +02:00
2.1 KiB
2.1 KiB
Install YunoHost on ARM board
Find other ways to install YunoHost here.
Before setting up a server at home, it is recommended that you know the [possible limitations imposed by your ISP](/isp). If they are too restrictive, you might consider using a VPN to bypass them.
Pre-requisites
- An ARM board with 500MHz CPU and 512 MB of RAM;
- A power supply for your board;
- A microSD card: 8GB capacity (at least) and Class 10 speed rate are highly recommended (like the Transcend 300x);
- An ethernet cable (RJ-45) to connect your board to your router;
- A reasonable ISP, preferably with a good and unlimited upload bandwidth.
Install with the pre-installed image (recommended)
0. Download the pre-installed image for your board
If no pre-installed image exists for your board, you can follow the instructions to "Install on top of ARMbian"
1. Flash the SD card with the image
2. Boot the board and connect to the web interface at yunohost.local
3. Proceed with the initial configuration (post-installation)
Install on top of ARMbian
0. Download the ARMbian image for your board
1. Flash the SD card with the image