Install YunoHost on ARM board

Find other ways to install YunoHost here.

Before setting up a server at home, it is recommended that you know the [possible limitations imposed by your ISP](/isp). If they are too restrictive, you might consider using a VPN to bypass them.

YunoHost doesn't yet support ARM64 boards. For more information, see [this issue](https://github.com/YunoHost/issues/issues/438).

Pre-requisites

An ARM board with 500MHz CPU and 512MB RAM ;
A power supply for your board ;
A microSD card: 8GB capacity (at least) and Class 10 speed rate are highly recommended (like the Transcend 300x) ;
An ethernet cable (RJ-45) to connect your board to your router ;
A reasonable ISP, preferably with a good and unlimited upload bandwidth.

Install with the pre-installed image (recommended)

0. Download the pre-installed image for your board
If no pre-installed image exists for your board, you can follow the instructions to "Install on top of ARMbian"

1. Flash the SD card with the image

2. Plug & boot

3. Connect to your server with SSH

4. Proceed to post-installation

Install on top or ARMbian

0. Download the ARMbian image for your board